Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
James Hardie Kitchen Remodeling: The Santa Clarita Owner’s Guide
A full kitchen remodel in Santa Clarita typically runs $14,000 to $45,000 when we install James Hardie-backed wall systems and premium cabinetry like KraftMaid. If you’re calling about a specific failed piece – a cracked cabinet frame, a swollen filler panel, a backsplash board that has pulled loose – most replacements get scheduled within the same week, and we won’t sell you a whole kitchen when a section will do. We’re an independent contractor, not affiliated with James Hardie; we install and repair their products because they hold up in this climate.

Owners usually find out something’s wrong one of three ways. A cabinet door stops closing flush and won’t adjust. The caulk line behind the backsplash starts showing a dark seam after a hot Canyon Country summer. Or a piece of trim near the sink swells and the paint lifts along the edge. All three point to moisture, movement, or hardware that has finally gone. The good news is that the fix is usually narrower than the fear suggests.
Which James Hardie Models This Applies To
James Hardie makes exterior cladding and trim board, not cabinets, so the “model” question on a kitchen page is really about two things: which Hardiebacker backer board is behind your backsplash or tile, and which Hardie trim or panel product is being used near a sink or wet wall. Hardiebacker comes in 1/4-inch and 1/2-inch thicknesses, in 3-by-5 and 4-by-4 sheets, and swapping a 1/4 for a 1/2 without adjusting your substrate will telegraph the difference through the tile. Hardie trim boards run in 5/4 and 4/4 nominal thicknesses in smooth or cedarmill texture, and the joint profile differs by line, so a mismatched piece at a butt joint shows.
Identify what you have before ordering anything. Look for the stamp on the backer board face or the printed end on a trim board, and measure the actual thickness with calipers rather than a tape. James Hardie publishes a printed install guide for each product online, and the install guide is the closest thing to a model number you’ll find. On the trim side, we source genuine Hardie board for wet-wall and painted-trim work in Santa Clarita, and we’ll also quote a quality aftermarket cement board when the spec doesn’t call for a branded sheet. That’s a straight cost-versus-lifespan call, and we’ll show you both numbers before you pick.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your James Hardie Kitchen Remodeling Is Failing
- Swelling at the base of a cabinet or filler near the sink. The board has absorbed water from a slow drip or a failing caulk line, and the fix is to replace the affected section and find the leak source, not just re-caulk over it.
- A hairline crack following a seam on the backsplash. The substrate has moved or wasn’t screwed down tight enough at install, and any repair that skips the substrate will crack again within a season.
- Loose cabinet hinges that won’t hold their adjustment. The hinge plate screws have stripped out of particleboard or MDF, and the correct fix is a hinge relocation plate or a hardwood rebuild, not a bigger screw.
- Dark staining or a musty smell behind the dishwasher or under the sink. Water has been sitting against a hard surface long enough to grow something, and this one needs the wet material cut out and the framing checked before anything gets closed back in.
- Trim board near the window swelling or the paint lifting off. Santa Clarita’s dry summers and monsoon-ish late-summer storms push water into seams, and a small trim repair is much cheaper than waiting for the wall behind it to go.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
| Job | Typical Installed Range (Santa Clarita) |
|---|---|
| Backsplash installation (Hardiebacker + tile) | $800 – $2,500 |
| Countertop installation | $2,000 – $6,500 |
| Cabinet installation | $4,000 – $13,000 |
| Kitchen island installation | $3,000 – $10,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Full kitchen remodel | $14,000 – $45,000 |
Those numbers include labor, material, haul-away, and permit if the scope triggers one. They don’t include surprises, which is why every scope line, every allowance, and every price change arrives as a written change order before we start. The spread in the range comes down to cabinet grade, countertop material, whether plumbing or electrical has to move, and whether the existing substrate is sound. Every job is backed by our written 90-Day Done Right Promise – if something isn’t right, one call and we’re back.
DIY or Call Us?
There’s a short list of things an owner can safely check: the hinge screws on a failing cabinet door, the caulk line behind the backsplash, the shutoff valve under the sink to see if a drip is real, and whether a hard surface flexes when you press it. Anything that requires opening a wet wall, moving a gas line for a new island, or working near the dishwasher’s electrical connection is where people get hurt or get a bigger bill than they started with. The gas and 120-volt work behind a kitchen wall is genuinely dangerous, and it’s not a weekend learning project. For everything else, the honest test is whether you’ll be comfortable cutting open the thing you’re trying to save. If not, call (833) 762-8116 and we’ll look at it with you. Estimates are free, and we’ll tell you straight if the fix is smaller than we expected.
FAQs
A properly installed Hardiebacker backsplash holds its seal for 15 to 25 years in this climate, and a Hardie trim board painted and caulked correctly should give 10 to 15 years before it needs attention. The lifespan is far more about the caulk and the paintable seal than the board itself. Call (833) 762-8116 for a free look at the piece that’s failing.
Yes, and in most cases that’s exactly what we recommend. A single failed cabinet, a cracked backer section, or a swollen trim board can be replaced in isolation if the surrounding work is sound. We’ll quote the small fix and the bigger one, and let you choose. Call (833) 762-8116 to talk it through.
A single trim board or a small backsplash section is usually a one-day job; a cabinet run or a backsplash over a full counter is typically two to four days. Timing depends on whether the substrate has to be rebuilt and whether the material is in stock. Call (833) 762-8116 for a firm schedule.
We source genuine James Hardie board through authorized suppliers and will quote quality aftermarket equivalents when the spec allows it, showing you both prices. We don’t stock parts on a truck, so expect two to five business days for a special order. Call (833) 762-8116 and we’ll confirm lead time on your exact piece before you commit.
If you’re standing in your Santa Clarita kitchen looking at a seam that won’t stop cracking or a cabinet that’s finally given up, we can help you price the real fix instead of the whole remodel. We’ve been answering our own phone and standing behind our work for over 29 years – you’ll get a written estimate, a clear scope, and a crew that carries our name. Call (833) 762-8116 today and let’s get you a free estimate, whether that’s a forty-dollar tube of sealant or a full kitchen in Santa Clarita that finally holds up. We also work with KraftMaid, Cambria, and Silestone when your project calls for cabinets or countertops alongside the Hardie work.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.