Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Blanco Home Additions & ADU: The Santa Clarita Owner’s Guide
We build Blanco-compatible home additions and ADU work for Santa Clarita homeowners, and most projects land between $45,000 and $130,000 depending on footprint, foundation, and finish level. ADUs run higher, typically $90,000 to $220,000, because they carry a full kitchen, bath, and separate utility. If you’re here because something on a Blanco-equipped project has gone wrong – a sagging header over the addition opening, a door that won’t latch square, a plumbing stub-out that’s leaking where a Blanco fixture ties in – we can look at it this week and tell you honestly whether it’s a repair or a rebuild. Call us at (833) 762-8116 and we’ll schedule a free estimate.

Most owners discover the problem slowly. A hairline crack shows up at the drywall seam where the addition meets the original house. A bedroom that was always comfortable runs hot by August. A Blanco rough-in valve under the new vanity starts weeping onto the subfloor. These are the tells that the original build cut a corner the inspector would have caught.
Key Takeaways
- Blanco-compatible additions in Santa Clarita run $45,000 – $130,000; ADUs run $90,000 – $220,000.
- Structural headers, foundations, and utility tie-ins are the three failure points we see most on older additions.
- We pull permits and get inspections signed on every eligible job. The permit record tells you what was actually built.
- Repairs we can make. Anything touching framing or gas isn’t a homeowner job, and we’ll tell you so plainly.
Which Blanco Models This Applies To
Blanco builds fixtures and finish components that turn up in kitchens and baths across Santa Clarita, and the model line matters when you’re matching anything. The SILGRANIT sink line (Precis, Valea, Diamond, and the Ikon apron-front) uses a composite granite material with specific cutout dimensions that differ by model – a Precis 1¾ bowl and a Diamond 1¾ bowl are close but not interchangeable on a countertop cutout. The BLANCO UNIT system, used in many ADU kitchenettes, pairs a sink with a matching tap and filtration in a single integrated piece, and the mounting spec is different from a standard undermount. If you’re ordering replacement parts, the model number is stamped on the underside of the sink flange or on a sticker on the cabinet door, and the spec sheet lists the exact cutout and drain offset.
Identifying the right part starts with that stamped number, not the shape. Owners often match visually and end up with a drain that’s 2mm off, which is enough to cause a slow leak at the tailpiece. For Blanco specifically, OEM parts are worth the call on sinks and strainers – the composite material is proprietary and aftermarket strainers often don’t seat flush. On general plumbing trim and taps, a quality aftermarket equivalent is fine and we use them regularly. We’re an independent contractor and not affiliated with Blanco; we buy their parts and install them, and that’s the whole relationship.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Blanco Home Additions & ADU Is Failing
- A crack at the seam where the addition joins the original house. This is usually foundation movement or a header that was undersized for the span. In Santa Clarita’s expansive clay soil, we see this most in Saugus and Canyon Country homes built on a slab with additions added after 2005.
- Doors that stick or won’t latch square. The framing has moved. It could be soil settlement, a missing post base, or a wall that was never properly anchored. A door that stuck gradually over two years is telling you something about the structure.
- A Blanco fixture leaking at the rough-in. The supply stub or drain connection under a vanity or kitchenette is weeping. On the BLANCO UNIT sink systems we’ve serviced, this is most often a strainer that was hand-tightened instead of seated with the right gasket sequence.
- Hot rooms, cold rooms, inconsistent air. The addition was ducted off the original HVAC without a load calculation. In Santa Clarita’s 100-degree summers, an undersized branch line is a real problem, not a thermostat issue.
- Permit history that doesn’t match the structure. You pull the record and the square footage on the addition isn’t on it. Or the ADU was built as a “storage room” and never permitted as habitable. We see this more than you’d think.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the work actually costs in Santa Clarita, calibrated to what we quote on real jobs:
| Project | Installed Range |
|---|---|
| Home Addition (Blanco-compatible kitchen, bath, or living) | $45,000 – $130,000 |
| ADU Construction | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
| Kitchen Remodel (within an addition) | $14,000 – $45,000 |
| Bathroom Remodel (within an addition) | $9,000 – $28,000 |
What drives the range: foundation type (slab vs. raised), whether the site needs grading, the span of the structural opening, and how deep the utility runs are. Finishes move the number too – a Blanco SILGRANIT sink and a KraftMaid cabinet package sit differently than builder-grade, and we quote both so you can see the difference. Every scope, every allowance, and every price change comes to you as a written change order before work happens. We pull the permits and get the inspections signed. The work is backed by our 90-Day Done Right Promise: if something isn’t right, you make one call and we come back.

DIY or Call Us?
Here’s the honest split. You can safely check the model number on your Blanco sink, photograph the crack at the addition seam, measure the door opening that’s gone out of square, and pull the permit record from the city. That’s useful information, and we’ll use it. What you cannot safely do is open a wall to inspect a header, dig around a footing to check for a post base, or touch the gas line to the ADU kitchenette. Structural and gas work isn’t a weekend project – it’s a call to a licensed contractor and, in Santa Clarita, a permit. We don’t say that to scare you. We say it because a failed header doesn’t fail slowly, and because the permit inspector works for you, not for us.
If you’ve got a crack, a sticking door, or a fixture that’s weeping, call (833) 762-8116 and we’ll come look. The estimate is free, and we’ll tell you straight whether it’s a repair or a rebuild.
FAQs
A properly built addition lasts 50 years or more. The variable in Santa Clarita is soil movement – expansive clay in parts of Saugus and Valencia, and post-fire soil instability in the Newhall and Placerita Canyon areas. A well-engineered foundation with proper drainage handles the movement. A foundation that skipped the soils report does not.
Sometimes. A leaking Blanco strainer or a shifted supply stub is a repair, usually a few hundred dollars. A cracked seam at the addition joint is a structural issue and repairs usually run into the thousands – though far less than a rebuild. A door that’s gone out of square because the framing moved needs the cause found, not the door replaced. We look at the cause first, then quote the fix. Call (833) 762-8116 for a free second opinion on any written estimate you’ve gotten.
A Blanco fixture swap – sink, tap, strainer – is a half-day job once the part is on site. Sourcing matters more than labor here. On the composite sinks and the BLANCO UNIT systems, we order from Blanco’s parts channel with the stamped model number, and lead time is typically a few days to two weeks depending on the part. On general plumbing trim, we can often source locally in Santa Clarita faster. We don’t stock parts and we don’t carry them on a truck – we order the right part for your model.
We source Blanco parts by model number from Blanco’s distribution channel, not by guessing from a photo. For the SILGRANIT sinks, the model number is stamped on the underside of the flange; for the BLANCO UNIT systems, it’s on the cabinet sticker. Bring us that number, or let us look at the fixture, and we order the exact spec. If your addition used KraftMaid, Cambria, or Silestone finishes alongside the Blanco components, we source those the same way. Call (833) 762-8116 and we’ll get the model number and order the part.
Barrett & Sons Construction Santa Clarita is the owner-operated alternative to the national outfits that quote one price on the phone and hand you a different bill at the door. Our crew members have up to 28 years of experience, every eligible job gets permits pulled and inspections signed, and every job is backed by the written 90-Day Done Right Promise. We’re an independent contractor and not affiliated with Blanco. Standing offers: $40 Off Any Repair Over $200, Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and a permanent 10% Senior & Veteran discount. Call (833) 762-8116 to schedule your free estimate.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.