Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Driveway & Pavers: The Santa Clarita Owner’s Guide
We install Schluter driveway and paver systems in Santa Clarita, and the installed price for the work most owners land on runs $7,000 – $18,000 for a paver driveway and $3,500 – $11,000 for a paver patio. We don’t stock parts, so if you’re hunting a single replacement piece, here’s what actually matters: which Schluter system you own, what failed, and whether the fix is a swap or a rebuild.

Owners usually figure out something’s wrong the same way. A paver settles a half inch below its neighbors on the approach to the garage, or a joint starts pumping sand every time the car rolls over it. Out back, water pools against the house after a storm instead of running to the street. By the time you’re on your hands and knees with a level, the failure has usually been building for a season or two.
Key Takeaways
- Schluter’s exterior paver systems rely on specific profiles, edge restraints and drainage components sized to your build.
- Most “part failures” in Santa Clarita trace back to base preparation and drainage, not the profile itself.
- We’re an independent contractor and not affiliated with Schluter.
- Free second opinion on any written estimate you’ve been handed.
Which Schluter Models This Applies To
Schluter’s paver work divides into two families, and knowing which one you have changes the whole conversation. Inside that scope, the components you’ll actually touch are edge profiles, joint spacers, drainage channels and the setting components underneath. Start by finding the original paperwork or the installer’s invoice; the system name and the profile line will be printed there. If the paperwork is gone, look at the edge restraint: Schluter’s paver edging profiles are extruded and have a distinct cross-section you can match against published spec sheets. Measure the height and width in millimeters with a caliper, not a tape.
The compatibility gotcha that bites people in Santa Clarita: profile height has to match your paver thickness exactly, and a mismatch of 2 or 3 mm shows up as a lip at every joint within a year of our summer heat cycles. OEM profiles from Schluter give you a verified spec match and a cleaner warranty story. Quality aftermarket equivalents can work, but only when the dimensions and material grade line up, and we’ve pulled more than one off-brand profile that was sold as a match and wasn’t. For finish work on these projects we also install KraftMaid, Cambria and Silestone indoors, though the outdoor work is strictly hardscape.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Driveway & Pavers Is Failing
- Ponding after rain. Water sitting in low spots for more than a day means the base has lost its slope. In Santa Clarita, our clay-heavy soil in areas like Saugus and Canyon Country swells and shifts with the wet-dry cycle, which pushes the base out of plane.
- Sand pumping at the joints. Every time you drive over the driveway, joint sand migrates. This points to movement under the pavers, not a shortage of sand. Re-sanding is the wrong fix.
- Lippage between pavers. A corner sitting 3 mm or more above its neighbor is a settling problem in the bedding layer. Left alone, the edges chip and the problem spreads.
- Loose or lifted edge profile. The restraint has lost its anchor, usually because it was set in soil instead of on a compacted base. Once the edge gives, the whole field starts to spread.
- Efflorescence that keeps returning. White salt staining that comes back after cleaning signals moisture trapped under the surface. In our climate the culprit is almost always drainage, not the pavers.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the work runs in Santa Clarita, installed:
| Work | Typical Range |
|---|---|
| Paver driveway installation (full) | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing (maintenance) | $250 – $700 |
The range is driven by square footage, how much base has to come out, access for equipment, and whether the failed section is a repair or a full rebuild. A localized fix, a few square feet of pavers reset with a new edge, costs less than a full field replacement; a full rebuild on a 600-square-foot driveway with a new compacted base lands toward the top. We quote a written line-item before work starts, parts and labor separated, and any change to scope gets a written change order before anyone touches a shovel. The finished work carries our 90-Day Done Right Promise: if it isn’t right, we come back.
DIY or Call Us?
A few things you can safely check yourself. Look for the installer’s invoice. Photograph the edge profile and measure it. Watch where water pools after rain. Re-sanding joints is a maintenance task you can handle; so is sealing with the right product every couple of years.
What goes wrong with DIY is the base. Resetting a settled paver sounds simple until you find the failure is in the compacted gravel underneath, and fixing that means pulling up more pavers than you planned, re-compacting to spec, and re-establishing slope away from the house. If you skip the base work, the pavers settle again within a season. Lifting a paver that’s been set for 12 years without breaking the bond and chipping the edge is its own skill. Call (833) 762-8116 for a free estimate and a written scope before you buy a single paver.
FAQs
A properly installed Schluter paver system should hold up 20 to 30 years before the pavers themselves need replacement, but the base and drainage need attention every 5 to 10 years in our climate. Our dry summers and wet winters stress the base more than most homeowners expect. Call (833) 762-8116 for a free assessment.
Often yes, if the failure is localized to a few pavers or one edge section. If the base under those pavers is sound, we can pull, reset and re-key the joint without touching the rest of the field. If the base has shifted, a patch just postpones the problem. We’ll tell you which one you’re facing.
A localized repair typically takes one day; a full paver driveway replacement runs 3 to 5 days depending on square footage and how much base comes out. The base work is what takes time. Rush it and the pavers settle faster than the first set did.
We don’t carry parts on a truck and we don’t stock them, so sourcing is handled per job through Schluter’s licensed distribution. Once we know your system, we order the exact profile for your paver thickness and verify dimensions before installation. Call (833) 762-8116 for a free estimate.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.