Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Fence Installation: The Santa Clarita Owner’s Guide
Boral doesn’t make a fence panel or a post, and that trips people up right away. Boral’s exterior products are siding, trim, and cladding – so when a Santa Clarita homeowner says they want “Boral fence installation,” what they usually mean is a fence built to match or complement a Boral-clad home, or a composite/hardboard panel system swapped in where a Boral-spec component used to sit. A straightforward privacy fence run in Santa Clarita, installed with materials matched to your Boral exterior, typically lands between $3,500 and $9,000 depending on linear footage, height, and gates. Most owners discover the problem the same way: a panel sags after a windy spring, a post base rots out below grade, or a gate latch stops catching because the pickets have swelled and shifted.

Which Boral Products This Applies To
Boral’s U.S. exterior line centers on siding and trim – things like Boral TruExterior trim, which is a poly-ash composite, and cladding profiles you’d find on the exterior wall, not the property line. If your fence project exists to visually tie into that siding, the compatibility question is color, profile, and thickness, not “which Boral fence series.” Boral TruExterior trim, for example, is engineered for exterior use with minimal movement and takes paint well, which is why it shows up as trim boards on gates and fence caps more often than as a fence panel itself.
To identify what you actually have, look for the material stamp on the back face of any panel or trim board, measure the board thickness (composites often run 1/2-inch to 1-inch in trim profiles), and snap a photo of the profile end. Sizes and trim profiles have changed across Boral’s product generations, so a match on name alone won’t guarantee a fit. The OEM-versus-aftermarket decision here is real: a genuine Boral trim board matched to your home’s existing color lot is the safest match, while a quality composite equivalent can work for fencing where the trim meets the fence line but not for repairs to the siding itself.
Barrett & Sons Construction Santa Clarita is an independent service provider and is not affiliated with Boral. We install and repair fence systems that tie into Boral exteriors – and we handle KraftMaid, Cambria, and Silestone on the interior side when a project spans both.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Fence Installation Is Failing
- Posts leaning or twisting after a wet winter. Santa Clarita’s clay-heavy soil shrinks and swells with the seasonal rain-to-drought swing, and a post footed in concrete without proper drainage will heave. Two seasons of that and the whole run pulls out of line.
- Rot or soft spots at the base of pickets and trim. Standing irrigation spray against a fence line is the usual culprit – drip systems aimed at the fence instead of the planting bed soak the bottom 18 inches year-round. Probe the base with a screwdriver; if it sinks easily, the wood is gone.
- Groaning or a stuck gate. A gate that drags, sticks, or won’t latch is almost always a hinge-side post that’s shifted, not a hinge problem. The sag is the symptom; the post is the cause.
- Loose pickets or wobbly rails. A fence in Santa Clarita takes wind gusts through the Newhall Pass that will work loose fasteners over a season or two. If single pickets move independently, the fastening has failed.
- Color fade, chalky surface, or paint peeling in sheets. Composite and hardboard trim can chalk and fade under strong Santa Clarita sun. Paint peeling in sheets rather than flaking usually means moisture is getting behind the board.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Santa Clarita, fence installation runs $3,500 to $9,000 installed, and the spread comes down to four drivers: linear footage, fence height (6-foot privacy versus a shorter decorative run), gate count and hardware, and whether old fencing and footings need to come out first. Repairs on a single section sit well below that range and get quoted separately.
What’s included in a written estimate: materials itemized by name and quantity, labor, gate hardware, old fence removal, and disposal. Every scope, every allowance, and every price change arrives as a written change order before work happens – no surprise invoice at the end. Every eligible job gets a permit pulled and inspections signed, and every completed fence is backed by the 90-Day Done Right Promise in writing. Call (833) 762-8116 to schedule your free estimate.

DIY or Call Us?
There’s a safe middle ground here. You can probe posts for rot with a screwdriver, measure panel and trim thickness, photograph any material stamp, and verify a gate’s sag by sighting down the posts. Those checks cost nothing and tell you a lot.
Where DIY goes wrong: digging out and resetting a concrete-footed post is heavy work with real injury risk, and setting a post to the depth, plumb, and drainage a Santa Clarita soil profile needs is where most fence failures start. Rushing a footing means doing the whole job twice. If a panel or gate assembly is involved, getting the fastening pattern wrong on composite trim can split it. Call (833) 762-8116 for a free estimate and a second opinion on any written quote you already have.
FAQs
A well-built fence with properly footed posts and quality composite or hardboard components typically holds 15 to 25 years in Santa Clarita. The posts fail first, not the panels, because our soil swing and irrigation habits attack the base. Ask us to check the footings before assuming the whole fence needs replacing.
Often, yes. A single leaning post, a sagging gate, or a handful of split pickets can usually be repaired without touching the rest of the run. If more than a third of the posts are loose, a full replacement usually costs less per foot than staggered repairs.
Most residential fences in Santa Clarita take one to three days once materials are on site. A permit and inspection add time on the front end, and we file those before work begins rather than after.
We measure the existing profile and thickness, photograph any manufacturer stamp, and order the matched material by specification. Boral trim colors and profiles have shifted across product generations, so a name match alone isn’t enough. Call (833) 762-8116 – estimates are free.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.