Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Barrette Home Additions & ADU: The Santa Clarita Owner’s Guide
If you have a Barrette addition or ADU framing package that’s failing, a like-for-like replacement or rebuild in Santa Clarita typically runs $45,000 – $130,000 installed for a home addition and $90,000 – $220,000 for a full ADU, depending on square footage, foundation, and finishes. We install and rebuild Barrette-compatible structures across the Santa Clarita Valley, and we quote the whole job in writing before anything moves. Owners usually discover a failure the same way: a sticking door that won’t square up, a hairline crack at a header, or a roofline that’s visibly sagging over the addition.

Barrett & Sons Construction Santa Clarita is an independent contractor. We’re not affiliated with Barrette, and we don’t claim to be – we work with Barrette-compatible materials and hardware the same way we work with KraftMaid, Cambria, and Silestone on the interior side of these jobs.
Which Barrette Models This Applies To
Barrette components show up across a wide range of addition and ADU builds in Santa Clarita, from detached backyard units in Saugus and Canyon Country to two-story bump-outs off existing footprints in Valencia and Stevenson Ranch. The part you need depends entirely on what’s actually stamped, labeled, or spec’d on your original drawings – not on what a photo of a similar build looks like.
Here’s how to find the right match:
- Check the label or stamp first. Barrette framing connectors, hangers, and structural hardware carry a manufacturer stamp or a label on the packaging if you still have the original paperwork. Match the stamp to the series before you order anything.
- Measure the actual opening, not the old part. A hanger that’s been stressed or a connector that’s pulled will read slightly off. Measure the joist, the beam, and the gap, then compare to the spec sheet.
- Match the series, not just the size. Two connectors can look identical and carry different load ratings. The wrong series is how you get a failed inspection – and in Santa Clarita, the inspector will catch it.
- OEM vs. quality aftermarket. For structural hardware, we stick with OEM or an equivalent rated to the same load. For finish components – doors, trim, glazing – a quality aftermarket match is usually fine and often less expensive. We’ll tell you which is which before you spend a dollar.
We don’t stock parts and we don’t carry inventory on a truck. We source what your build actually needs, in writing, with the spec sheet attached.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Barrette Home Additions & ADU Is Failing
Structural problems in an addition or ADU rarely announce themselves. They show up as small symptoms that get worse. Here’s what we see most often in Santa Clarita:
- Doors and windows that stick or won’t latch. That’s usually a sign the framing has shifted or settled – often a connector that’s loosened or a header that’s deflecting. If it started suddenly, get it looked at.
- Hairline cracks at corners, headers, or where the addition meets the original house. Some cracking is normal settling. Cracks that widen over a season usually mean movement that shouldn’t be happening, and often trace back to an under-rated connector or a foundation issue.
- A roofline that sags or a floor that bounces. Both point to deflection – a beam or joist carrying more than it was designed for, or a hanger that’s pulled. This is the one to take seriously.
- Water staining or rot at the connection points. Santa Clarita’s dry summers and occasional heavy winter rain are hard on exterior hardware and flashing. Rusted connectors and failed flashing are common after a wet season.
- Squeaks or popping sounds that weren’t there before. Movement you can hear is movement you should check. It’s often a fastener or connector backing out.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing in Santa Clarita depends on which part of the structure we’re replacing or rebuilding, the size of the footprint, and how much finish work gets touched. Here are the ranges we quote:
| Scope | Installed Range |
|---|---|
| Home Addition | $45,000 – $130,000 |
| ADU Construction | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
The range is driven by square footage, foundation and site work, whether we’re matching an existing roofline, and finishes – a shell rebuild sits at the low end, a finished ADU with a full kitchen and bath at the high end. What you get in every quote: parts and labor itemized line by line, permits pulled, and inspections signed. Santa Clarita requires permits on additions and ADUs, and we pull them every time – the permit inspector works for you, not for us.
Every change order arrives in writing before the work happens. No surprise invoices at the end. Every completed job is backed by our written 90-Day Done Right Promise – if it’s not done right, one call brings us back.
DIY or Call Us?
Here’s the honest split. You can safely check the cosmetic stuff yourself: look for cracks, listen for squeaks, test whether doors and windows still square up, and check exterior connection points for rust or rot after a wet winter. Take photos and note when the symptom started.
What we don’t recommend is replacing structural connectors, hangers, or load-bearing framing yourself. A home addition or ADU carries the weight of the structure above it, and an under-rated or improperly installed connector can fail with real consequences – especially in an area with seismic activity like the Santa Clarita Valley. This isn’t a part to guess at. If a connector or header is compromised, it’s worth a professional look before anything else happens.
We’re licensed, insured, and independent – if a symptom has you worried, call (833) 762-8116 and we’ll take a look. No trip charge inside the county, and we answer the phone day or night.
FAQs
A properly built addition or ADU is designed to last decades, but the connectors, flashing, and fasteners are the wear items – and Santa Clarita’s dry-hot summers and wet winters age them faster than a mild climate would. We typically see exterior hardware needing inspection after 15 – 20 years, and rusted or failed flashing is common after a hard rainy season. Call (833) 762-8116 for a free assessment.
Sometimes yes – a loose connector can be re-secured and a localized crack repaired without rebuilding the whole structure. But if the underlying issue is deflection, settling, or an under-rated part, a repair just buys time. We’ll tell you plainly which situation you’re in, and we’ll give you a free second opinion on any written estimate. Call (833) 762-8116.
A single connector or hardware replacement is usually a short job – often a day or less. A structural rebuild or a full addition scope runs weeks to months depending on permits and inspections. You’ll get a written timeline with your quote, not a verbal one. Call (833) 762-8116 for a free estimate.
We match the stamp, the series, and the actual measured opening on your build, then confirm the load rating against the spec for that application. We don’t stock parts – we source what your job needs and show you the spec before it’s ordered. Call (833) 762-8116 and we’ll walk you through it.
Call (833) 762-8116 for a free estimate. We answer live, day or night, no voicemail.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.