Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Kitchen Remodeling: The Santa Clarita Owner’s Guide
Ameristar kitchen remodeling in Santa Clarita typically runs $14,000 to $45,000 installed, and it is planned work, not same-day work – the schedule depends on the scope, cabinet lead times, and how fast the city pulls permits. What usually brings an owner to this page is a kitchen that has quietly failed somewhere: a cabinet door that swings past its stop, a drawer box that has stopped riding its runners, a countertop edge that has lifted from the substrate, or a finish that has clouded on the sun-facing run of cabinets.

Ameristar cabinetry and millwork show up in a lot of Santa Clarita homes built through the 1990s and 2000s, and the parts inside it wear at predictable points. When one fails, replacing the right component – or the right run of boxes – is almost always cheaper than the whole kitchen people assume they need. We’ll show you what actually fails, what the repair or partial remodel costs here, and where a homeowner can safely stop and call us.
Which Ameristar Models This Applies To
Ameristar is a cabinet and millwork line, not a single model, and the parts don’t interchange freely across its series. Before you order anything, find the label inside a cabinet door or on the back of a drawer box – most Ameristar boxes carry an identifier sticker or an ink stamp on the interior side panel near the hinge. Photograph it. The sticker tells you the box construction, the door style line, and the hardware family, and that last one is the detail that most often goes wrong: Ameristar used several hinge and slide families over the years, and a “standard” replacement slide won’t fit a box drilled for a different family.
You need three measurements to match any part: door overlay (how far the door sits over the box face), the hinge cup bore diameter and screw-hole spacing, and the drawer box depth plus the length of its runner. OEM Ameristar parts are the exact match, but they carry a lead time and a price premium. A quality aftermarket equivalent – a name-brand hinge or undermount slide matched to those three measurements – is often a better value and installs identically. We’ll tell you which way we’d go on your specific kitchen, and we’re an independent Santa Clarita contractor, not affiliated with Ameristar.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Ameristar Kitchen Remodeling Is Failing
- Doors that sag or rub the frame. The hinge is losing its spring tension or the screws have pulled from the wood. In Santa Clarita’s dry summer air, box wood shrinks and screw holes loosen faster than most owners expect.
- Drawers that stick, drop, or fall off the runner. The slide has worn or the cabinet side has swollen from a past leak. A dropped drawer box usually means the runner is one repair away from a full failure.
- Finish clouding or peeling on sun-facing cabinets. The Santa Clarita Valley gets intense afternoon sun through kitchen windows, and a finish that takes that light daily will break down years before an interior run does.
- A countertop edge lifting or a backsplash grout line cracking. The caulk or substrate under the surface has failed. Left alone, water finds the seam and the repair grows.
- A cabinet box that has pulled from the wall or the cabinet run has split at a corner. Fasteners loosened or the box has failed at the joint. This one gets a same-day look from us because it can drop.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Repairing or partially replacing Ameristar kitchen components in Santa Clarita lands in these installed ranges. Every one is a written, line-itemed estimate before work starts, and every price change arrives as a written change order – no surprise invoice at the end.
| Scope | Installed Range (Santa Clarita) |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the number is box count and cabinet line, door style and finish, whether we’re replacing the counter and backsplash at the same time, and how much the permit and inspection require. Parts plus labor are shown separately on the estimate so you see where the money goes. Every job we complete is backed by the written 90-Day Done Right Promise.

DIY or Call Us?
Some things you can safely check yourself: photograph the cabinet label, measure your door overlay, note which drawers stick or drop, and confirm whether the counter edge has lifted. A single loose hinge screw is a five-minute fix with the right screw.
Where DIY goes wrong is swapping a drawer slide into a box drilled for a different runner family, or attempting to re-hang a cabinet that pulled from the wall. A failed box fastener can drop a loaded run, and that’s a two-person job with the wall opened up. For anything beyond tightening a screw or snapping a photo of a label, call us. We’ll bring the right part and get it right. Call (833) 762-8116 for a free estimate.
FAQs
How long do Ameristar kitchen cabinets and components last in Santa Clarita? The boxes themselves typically hold up for decades, but hinges, slides, and the sun-facing finish wear faster here – expect slides to need replacement well before the box does, and sun-facing doors to show finish wear first because of the valley’s intense light.
Can my Ameristar part be repaired instead of replaced? Often, yes. A sagging door is usually a hinge or screw fix, and a sticking drawer is usually a worn slide. We’ll tell you honestly when a repair will hold and when replacing the part makes more sense.
How long does a part swap take? A hinge, slide, or single door swap is typically a short visit, often done in a couple of hours. A larger cabinet or countertop replacement takes longer and depends on lead time and permit timing – your written estimate will lay out the schedule.
How do you source my Ameristar part? We match by the label inside the cabinet and your three measurements, then source the OEM part or a quality aftermarket equivalent matched to your hardware family. We don’t claim to stock parts or carry them on a truck – we order the correct one for your model.
Call (833) 762-8116 for an exact quote. Estimates are free, and so is a second opinion on any written estimate you already have. We also service KraftMaid, Cambria, and Silestone kitchens when your remodel touches those brands.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.