Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Driveway & Pavers: The Santa Clarita Owner’s Guide
Cambria is quartz, not a paver brand, so if you’ve landed here with driveway or hardscape trouble, the connection is almost always the same: you had a Cambria quartz project done (kitchen, bath, outdoor counter) and the crew that cut it left the job with your driveway, walkway, or paver patio carrying the mess or the damage. We handle both sides of that in Santa Clarita: Cambria-compatible surface work and full paver and driveway installation and repair, with paver driveway installation running $7,000 – $18,000 and concrete driveway installation $4,500 – $12,000. We’re an independent contractor, not affiliated with Cambria, and we don’t dispatch from a warehouse or stock parts on a truck. What we do is put the work in writing and show up when we said we would.

Most Santa Clarita owners figure out something’s wrong the same way. They walk out one Saturday morning and the driveway is stained with rust-colored slurry or grout haze that won’t scrub out. Or the paver joints near the garage apron have heaved, and the rubber seal at the bottom of the door is riding a half inch above the surface. Another common one: the paver walkway that ran along the side of the house has sunk two inches at the corner where the downspout dumps, and every rain sends water back toward the foundation instead of away from it.
Which Cambria Models This Applies To
Cambria quartz slabs come in a range of series and thicknesses, and if your driveway or paver situation is tied to a stone install, the first thing to establish is what was actually used. Standard interior slabs are typically 2 cm or 3 cm thick. Outdoor-rated Cambria applications (countertops, bar tops, outdoor kitchen surfaces) sit in the same thickness range but need to be supported on a solid substrate, not overhung. When we look at your job, we read the fabricator’s sticker or the original contract, measure the exposed edge, and match it against the slab. If you don’t have the paperwork, we can usually identify it from the surface finish and edge profile.
The OEM-versus-aftermarket decision on the driveway side is simpler than most people expect. For pavers, there is no true “OEM part.” There are brand families (Belgard and Techo-Bloc are the ones we install), and each has a fixed set of dimensions and colors per series. Matching a discontinued or out-of-stock paver is where it gets tricky. We don’t carry inventory and we’re not going to tell you we have your exact color sitting on a shelf. What we can do is check current series specs, find the closest match, or blend the repair into a new band or border so the mismatch reads as intentional. For the Cambria stone itself, that’s a Cambria product and any warranty or fabrication questions go to them or the fabricator, not to us.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cambria Driveway & Pavers Is Failing
- Rust-colored or white staining across the driveway. That’s usually slurry, grout haze, or acid etch from a stone fabrication job, not something that washed in. It won’t come out with a hose or a pressure wash. It needs the right cleaner and, sometimes, resurfacing.
- Paver joints that heave or open up. Santa Clarita’s clay and sandy soil moves with seasonal moisture swings, and a joint installed without a proper base layer or without polymeric sand patched in correctly will open within a season or two.
- Low spots holding water near the garage apron or foundation. Standing water against a slab or foundation is the real problem, not the paver. It means the slope went wrong, and the fix is re-grading, not just topping off sand.
- Loose or rocking pavers underfoot. One or two loose pavers usually means the bedding layer failed or the base compacted unevenly. Left alone, they migrate and take the neighbors with them.
- Cracks or spalling in a concrete apron or driveway edge. Santa Clarita’s inland heat swings from mild winters to 100-degree summers, and a thin pour or a drive-over edge without expansion joints will crack along the seam within a few years.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s where the money goes on a Santa Clarita driveway or paver job, and what it covers. Every range below is installed, not materials-only.
Paver driveway installation: $7,000 – $18,000. The low end is a smaller, straightforward rectangle on a simple grade. The high end includes excavation, base prep over Santa Clarita’s expansive clay, and brand-series pavers from Belgard or Techo-Bloc. Demolition of an old surface, deep base work, and any drainage corrections push you toward the top of that number.
Concrete driveway installation: $4,500 – $12,000. A standard broom-and-joint pour lands in the middle of this. Decorative finishes, wide aprons, and reinforced slabs for heavier vehicles move up the range.
Asphalt driveway paving: $3,500 – $9,000. The cheapest per square foot up front, and the fastest to resurface, but shorter life under California sun. Driveway replacement overall runs $5,000 – $14,000, and driveway sealing runs $250 – $700 when you just need to buy time.
What you get on every Barrett & Sons job: a scope and allowance in writing, a price change in a written change order before it happens, permits pulled and inspections signed on eligible jobs, and our written 90-Day Done Right Promise. If it’s not done right, one call brings Tom back to fix it.
DIY or Call Us?
Some of this you can safely check yourself. Walk the driveway after a rain and mark where water pools. Look at whether the paver sand between joints is still there or has washed out. Check that the downspouts discharge onto a slope that runs away from the house. Those are useful observations, and we’d much rather hear them from you than not.
What we don’t recommend as a DIY project: pulling pavers and re-bedding them yourself, or trying to fix a concrete apron with a bag of mix. Both fail quietly and then fail loudly. Repairs that look done but sit on a bad base come apart within a season, usually right after the first hot week. And anything that involves moving the slope near your foundation should be measured before it’s dug, not after. If you’re not sure which of those you’re looking at, call (833) 762-8116. We’ll take a look and give you a straight estimate.
FAQs
Expect 25 to 40 years on a sound base with proper joint sand and re-sealing every three to five years. The base is what decides that, not the paver. A Belgard or Techo-Bloc series installed on a compacted, properly graded base survives Santa Clarita’s summer heat and winter rain far longer than one dropped on minimal excavation. If your base was skipped, the drive tells you within the first few seasons. Call (833) 762-8116 to get a free estimate on getting the base right.
Often, yes. A few loose pavers, opened joints, or one cracked apron section can be reset or repaired without tearing out the whole drive, which is much cheaper than the full $7,000 – $18,000 paver installation. What can’t be repaired: an overall slope that sends water toward the house, or widespread base failure. In that case, patching just buys a season. We’ll tell you which one you’re facing in the estimate, and it’s free. Call (833) 762-8116.
A small repair, like resetting a handful of pavers or patching an apron section, is usually a day to two days. A full paver driveway installation for a typical Santa Clarita home runs about three to five days, depending on demolition, base depth, and drying time. We give you a written schedule before work starts and a written change order for any scope change. That way the number you agree to is the number you pay.
We source through our trade channels from named brands like Belgard and Techo-Bloc, working from your existing paver’s dimensions and series. We don’t carry inventory and we won’t promise a perfect match on a discontinued color, but we can usually find the closest current series or design a border or band that makes the blend look deliberate. Cambria quartz itself is a Cambria product, and we handle installation and surrounding surface work as an independent contractor, not affiliated with Cambria. For a specific material question, call (833) 762-8116 for a free estimate.
We also work with KraftMaid, Silestone, and Kohler on the indoor side, so if your project runs from the powder room to the driveway, we can keep it under one scope in writing.
Cambria quartz on the counter, pavers on the drive, one crew in Santa Clarita that answers the phone live, day or night. No mystery brands off a van, no surprise invoice at the end, permits pulled and inspections signed on eligible jobs, and a written 90-Day Done Right Promise to back every bit. If you’ve been burned by a national outfit that quoted one price on the phone and handed you another at the door, this is where that stops. Call Barrett & Sons Construction Santa Clarita at (833) 762-8116 to schedule your free estimate. Ask about our standing offers: $40 Off Any Repair Over $200, Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and a permanent 10% Senior & Veteran discount. Our crew members have up to 28 years of experience, and Tom’s sons run the crews most days. Look up the name before you sign anything. Then call.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.