Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Bathroom Remodeling: The Santa Clarita Owner’s Guide
A bathroom that’s built right with IKO materials typically runs $9,000 – $28,000 in Santa Clarita, depending on how far the scope goes and which IKO system the room uses. We install IKO-compatible bathroom assemblies, source the right IKO components to match what your home already has, and build the job on a written scope with a fixed price. Once that IKO assembly is doing its job, a properly kept bathroom holds for a very long time.

Owners usually find out something’s wrong with the IKO wet-area assembly the same way. The grout at the shower floor turns dark and stays dark after a scrub. A soft spot shows up in the drywall on the other side of the wall. The drip pan on the IKO shower base starts holding a little water that won’t drain out. Or you pull up a loose floor tile and the cement board underneath is damp. In every case, water found a path past an IKO seal, membrane, or base system, and the clock on the damage has been running well before you noticed a thing.
Which IKO Models This Applies To
IKO’s bathroom line runs through its waterproofing and underlayment systems, and each one carries its own model and series codes printed on the package, the roll core, or the spec sheet. The material you’re replacing or matching has to line up exactly: IKO waterproofing membranes and shower bases are spec’d by thickness (often in the 30-mil to 40-mil range) and by square-foot coverage per roll, so a membrane from the wrong series won’t lap or bond the way your assembly was built to do. IKO tile backer and underlayment panels differ by thickness and edge profile, and IKO shower bases are keyed to drain and flange dimensions by model, not by size.
To identify the right part, look for two things. First, a printed label or code on the packaging or backing that survived the installation. Second, physical measurements: drywall-to-drywall span of your shower alcove, drain center offset, membrane thickness with a caliper if you have one, and the depth of your existing base. When the label’s gone, measurements get you there. On the OEM-versus-aftermarket call for IKO specifically, an exact IKO match is the right move when the surrounding assembly is intact and staying; a quality aftermarket equivalent makes sense only when the whole wet-area system is being rebuilt and the pieces don’t have to lap against existing IKO materials. We source to match, we don’t carry parts, and we’ll tell you plainly which way your Santa Clarita bathroom points once we’ve measured it. We’re an independent service provider, not affiliated with IKO.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Bathroom Remodeling Is Failing
The failure signs in an IKO bathroom assembly are consistent, and so are the causes behind them. Here are five we see in Santa Clarita homes:
- Grout that darkens and won’t clean up. Water is moving through the tile face and the grout is holding moisture that never fully dries, which usually means the IKO membrane behind the tile has a break or the seam was never properly lapped.
- A soft, spongy spot in the subfloor near the shower or tub. Long-term moisture trapped under the IKO base has reached the plywood, and softness means the wood is already giving way rather than just damp.
- Water standing in the IKO shower base that won’t drain. A poor weep-age setup or a drain flange that wasn’t seated to the IKO base spec leaves water with nowhere to go, and the constant standing water accelerates everything downstream.
- Bubbling, staining, or a musty smell on the wall behind the shower. Moisture has crossed the IKO waterproofing and reached the back side of the drywall, which is the first place a homeowner can actually see it.
- Caulk seams at the IKO base and wall that pull away and won’t stay sealed. Repeated failure at the joint points to movement or a poor bond because the seam prep and IKO products weren’t matched to the base material.
Replacement Cost & What’s Included
A full IKO-compatible bathroom remodel in Santa Clarita runs $9,000 – $28,000 installed. A smaller footprint bathroom stays in the $5,000 – $12,000 range. A walk-in shower installation lands at $4,500 – $12,000, a tub-to-shower conversion at $3,500 – $10,000, and a shower replacement alone at $3,000 – $8,500. A vanity swap is $800 – $3,000.
What drives the range is the tile and base selection, how much of the existing assembly comes out, whether the subfloor is sound, and whether a permit is needed to change the wet-area configuration. Our price includes the IKO and compatible parts plus labor, quoted line by line in writing before the first piece comes out. If the scope changes mid-job, the price change arrives as a written change order before anyone touches the work, and every job carries the written 90-Day Done Right Promise. Call for a current figure.

See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this you can check yourself, and it’s worth doing. Pop a loose trim piece and look at the back side of the wall for staining. Press the subfloor around the shower base for soft spots. Run water in the shower and watch whether the IKO base drains out and stays dry. Do not pull up the shower base or cut into a waterproofing membrane on your own: the membrane in an IKO wet-area assembly is bonded and sealed as one system, and a homeowner repair that looks tight will let water through at the very seam you can’t see, which is where the real damage starts. That’s the line. Checking is fine. Tearing into the membrane is a call to a pro.
Bring us your measurements and the codes off your IKO packaging, and we’ll tell you what you’re holding. Call (833) 762-8116 for a free estimate.
FAQs
How long does an IKO bathroom assembly last in Santa Clarita? A properly installed IKO waterproofing and base system generally holds up for 15 to 25 years before the materials need to be replaced, and many go longer. The variable in Santa Clarita’s climate is heat and sun on the home’s exterior pathing; interior wet-area wear follows water exposure far more than temperature, so daily drying and prompt caulk upkeep are what move the number most. Call for a specific read on your assembly.
Can the IKO part be repaired instead of replaced? Often the failing piece can be repaired if the surrounding IKO membrane and base are still sound and water hasn’t reached the framing or subfloor. What usually makes repair the wrong move is when the assembly has been losing water for a while, which means the damage underneath goes deeper than the one failed part. We’ll tell you honestly which case you’re in before any work starts.
How long does the swap actually take? A single-part replacement like a shower base or a section of waterproofing runs one to three working days once the right part is in hand. A full IKO-compatible bathroom remodel runs one to three weeks depending on tile, fixture count, and whether we’re pulling a permit. Any change to that timeline reaches you as a written change order, not a phone call after the fact.
How do you source the IKO part? We match by the code on your IKO packaging where it survives and by precise measurements where it doesn’t, then source the exact IKO product through a distributor who stocks it. We don’t carry parts ourselves and we don’t keep stock, so your part is ordered specific to your bathroom. Call (833) 762-8116 and we’ll get the match moving.
Why Santa Clarita Homeowners Call Us
Barrett & Sons Construction has been owner-operated in the community since 1998. Tom Barrett publishes his name, his address, and his license number so you can look it up before you sign anything, and his sons run the crews. Every eligible job has the permit pulled and the inspection signed, and every scope, allowance, and price change arrives in writing before work happens. Our crew members have up to 28 years of experience, are background-checked, and carry the Barrett name. We also install KraftMaid, Cambria, and Silestone materials for the rooms around your bathroom.
Call (833) 762-8116 for a free estimate on your IKO bathroom project in Santa Clarita. A live person answers at any hour, and if you’d rather have us look over a written estimate you already have, that second opinion is free too. Santa Clarita homeowners have plenty of choices for bathroom work. We’re betting you’ll pick the one whose name you can verify and whose face you’ll see at the hardware store on Saturday.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.