Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Fence Installation: The Santa Clarita Owner’s Guide
Tamko fence installation in Santa Clarita typically runs $3,500 to $9,000 installed, depending on linear footage, material line, and gate count. We install Tamko fencing systems and match the correct rails, pickets, and hardware to your existing run so the repair blends in instead of standing out. Every eligible job is quoted in writing with a line-item price, and we pull the permits and sign the inspections. Fence damage rarely announces itself: most Santa Clarita owners notice it after a wind event lifts a rail loose, a post starts leaning in summer heat, or a gate that used to swing clean starts dragging its bottom edge. That drag is usually a failed hinge or a post out of plumb, not a problem with the panel itself.

Key Takeaways:
- Installed Tamko fence work in Santa Clarita lands at $3,500 – $9,000.
- Match the Tamko line before you buy rails or pickets – profiles differ by series.
- Quotes come in writing, change orders come in writing, and the 90-Day Done Right Promise is on the contract.
- Call (833) 762-8116 and a live person answers, day or night.
Which Tamko Models This Applies To
Tamko builds fencing across a few material lines, and the details that matter for installation are rail gauge, picket profile, and post spacing. The series name is usually stamped on the rail end or printed on the panel tag; if the tag is gone, measure the rail height and the picket width and bring those numbers to us. Most residential runs in Santa Clarita fall in the same three rail heights, so a measurement gets you matched faster than a year and a model name.
The OEM-versus-aftermarket call for Tamko fencing is genuinely a wash in most cases. Original Tamko rails and pickets keep the color and profile identical to the run you already have, which matters on a visible front fence. A quality aftermarket rail from a comparable gauge holds up fine on a side or back run and can cost noticeably less. We tell you which is which before you decide. What we don’t do is claim a warehouse full of parts sitting on a shelf – we source what the job needs and order it in. Barrett & Sons Construction Santa Clarita is an independent contractor and is not affiliated with Tamko. We also handle KraftMaid, Cambria, and Silestone products on the interior side, so if you’re working both ends of the house, ask in the same call.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Fence Installation Is Failing
- Posts leaning after a wet winter. Santa Clarita’s clay-heavy soil swells when saturated and shrinks hard in summer, and a post set shallow or without proper footing will walk out of plumb. If the lean shows up on more than one post along a run, it’s soil and depth, not bad luck.
- Rails lifting out of the post pockets. Santa Clarita gets Santa Ana wind gusts that push hard on long unbroken runs. A rail that has popped its fastener is usually the first sign the run is catching more wind than the bracket spacing was set for.
- Gate dragging or sagging at the latch side. The gate is the highest-load part of any fence, and a hinge that has stretched or a post that has settled shows up here first. Dragging is a mechanical failure, and it gets worse fast once the hinge wears further.
- Cracked or splintered pickets along the sun side. The western exposure in Santa Clarita is brutal on any fence material. Fading is normal; splintering and hairline cracks mean the picket finish has given up and moisture is getting in.
- Fasteners backing out or rusting at the post line. Loose screws at the rail-to-post connection mean the run is moving more than the hardware was sized for. Rust at that joint means water is pooling where it shouldn’t.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Fence installation in Santa Clarita comes in at $3,500 to $9,000 for a typical residential run. The range comes down to linear footage, fence height, material line (vinyl, aluminum, or composite), post count, gate count, and how much old fence has to come out and go to the dump. A short run with one gate sits at the bottom of that range; a long perimeter with two gates and a corner post pull sits at the top.
What you get in a written quote:
- Line-item pricing: materials, labor, removal, haul-away, permits.
- Post footings dug and set to depth for solid bearing.
- Gate hardware set and adjusted so the latch catches clean.
- Permits pulled and inspections signed on every eligible job.
Any change to scope or materials arrives as a written change order before the work happens, and every completed job carries the 90-Day Done Right Promise in writing – one call brings Tom back if something isn’t right.
DIY or Call Us?
Checking your fence is safe to do yourself. Walk the run and look for lean, popped fasteners, gate drag, and cracked pickets; measure your rail height and picket width so you know what you’re replacing. Replacing a single picket or tightening a hinge is well within reach for a homeowner with a drill and an afternoon.
Where DIY goes wrong is the post. Setting a fence post to depth, getting the footing right, and plumbing a run so the gate doesn’t sag next spring is real work, and a post that’s set shallow is a redo in two years. Digging near any buried utility line is dangerous – call 811 before you put a shovel in the ground anywhere near a fence line. Gate rebuilds, post replacement, and full runs are where we earn the call.
If you’re not sure which side of that line you’re on, call (833) 762-8116 and we’ll talk it through. The second opinion on any written estimate is free.
FAQs
A properly installed Tamko fence generally gives 15 to 25 years in Santa Clarita conditions, though the western sun exposure and clay soil mean post footings and gate hardware usually need attention well before the panels do. The fence face holds up; the connections underneath are what you watch.
Yes, in many cases – a handful of pickets, a gate hinge, or a single leaning post can often be repaired without touching the rest of the run. A full replacement makes sense when posts are failing across the run or the good pickets are fewer than the bad. Call (833) 762-8116 for a free estimate and we’ll tell you which side of that line you’re on.
A typical residential run takes one to three days once materials are on site, and we schedule it in writing before we start. Post-set time and inspection scheduling add to the calendar, not to the work itself. Call (833) 762-8116 for a date on your job.
We measure the rail height, picket width, and post spacing on your existing run, match it to the Tamko line, and order the material for the job. We don’t claim stock on hand – we order what fits. If the OEM part isn’t available in the profile you need, we’ll quote a quality equivalent and show you the difference in writing before you decide.
Call (833) 762-8116 for a free estimate. A live person answers 24 hours a day, seven days a week. Every quote is written, every change order is signed before work moves, and the permit inspector works for you, not for us – that’s why we like him. Ask about the $40 off any repair over $200, the free second opinion on any written estimate, no trip charge inside the county, and the permanent 10% Senior and Veteran discount.
Written by the team at Barrett & Sons Construction Santa Clarita, serving Santa Clarita and nearby areas.