Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Roofing: The Santa Clarita Owner’s Guide
Roof repairs on a Therma-Tru home in Santa Clarita typically cost $400 – $1,800, and replacing the roof runs $8,000 – $20,000. A failing section can usually be diagnosed the same day you call, and small repairs are often scheduled within the week.

Most owners here don’t learn about a roofing problem from a Therma-Tru label. They learn it from the ceiling. A brown ring spreads across the drywall in the hallway. The fiberglass shingles over the valley start curling at the edges after another dry summer. Or the skylight flange pulls loose and the first Santa Clarita rain in November finds its way inside before the dew even burns off. One note up front: Barrett & Sons Construction is an independent contractor and is not affiliated with Therma-Tru. We install and repair roofing and the exterior trim that Therma-Tru homes are built with, and we’ll tell you straight whether a Therma-Tru-specific part is even the right answer or if the problem belongs to the roof deck and flashing.
Which Therma-Tru Models This Applies To
Therma-Tru is known mainly for doors, so let’s clear up the confusion first. On a Santa Clarita home, the Therma-Tru product that shows up around the roofline is the door and sidelight system under a porch or entry overhang, not the roof itself. Roofing above a Therma-Tru door system has to be flashed and finished so water sheds away from the frame, sill, and threshold. That means the part you’re looking for isn’t a shingle stamped “Therma-Tru.” It’s the correct flashing, drip edge, and head casing that ties a Therma-Tru entry back into the roof without trapping water against it.
How to identify what you actually have
- Look at the door jamb label on your entry door for the Therma-Tru model series before you buy anything. The threshold plate and the jamb tag carry the model line.
- Photograph the roof-to-head transition where the overhang meets the top of the door frame. That joint is where leaks over Therma-Tru entries almost always start.
- Measure the rough opening and the existing drip edge width in inches. Therma-Tru entry systems come in standard door widths, and the flashing has to lap past the frame, not sit flush.
On the OEM-versus-aftermarket call: for the door itself, we recommend genuine Therma-Tru parts so the door warranty stays intact. For the roofing and flashing above it, a quality aftermarket drip edge and step flashing are perfectly fine and often what your local supplier carries. We can order either and we don’t claim to stock parts or carry them on a truck, so expect us to source what your exact setup needs.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Roofing Is Failing
Here’s what a failing roof over or around a Therma-Tru entry actually looks like in Santa Clarita:
- Water staining on the interior header above the door. The flashing and head casing above the frame have separated, letting water track down behind the trim. By the time you see the stain, the leak has been running for a while.
- Shingles curling or lifting at the overhang edge. Our inland heat – a lot of Santa Clarita afternoons top 100 degrees in summer – bakes the exposed edge over the entry first, so that section ages faster than the rest of the roof.
- Peeling or bubbling paint on the door head and casing. Moisture is getting trapped between the siding and the roof edge. Paint fails before wood rots, so it’s the early warning.
- The door sticking or rubbing at the top corner. A slow roof leak over the frame swells the header and throws the entry out of square. This is the one owners blame on the door when the roof is the real culprit.
- Visible gaps or backer rod showing at the roof-to-wall transition. Caulk and membrane have worn through, and wind-driven rain off the Santa Clarita hillsides pushes straight in.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Roof repair in Santa Clarita runs $400 – $1,800, and full roof replacement lands between $8,000 – $20,000. Flashing and trim work around a Therma-Tru entry usually falls in the lower half of the repair range. Tile roof repair is $600 – $2,500 if your home has a tile profile over the entry.

What moves the number: how much decking has to come up, whether we’re resetting flashing only or re-roofing a whole section, attic access, and matching shingle or tile to what’s already there. We quote parts and labor as separate lines so you can see what the material costs and what the work costs. Any change to the scope arrives as a written change order before anyone touches the roof. Every job we take on carries the 90-Day Done Right Promise, written on the contract – if it isn’t done right, one call brings us back.
DIY or Call Us?
What’s safe to check yourself: look for stains on the ceiling and header from inside, photograph the roof-to-entry joint from the ground with your phone zoomed in, and confirm your door model from the jamb label. That’s it. Roof work here means heights, and a fall off a two-story entry in Santa Clarita is not a repair you shrug off. Beyond the danger, the flashing above a Therma-Tru entry has to be layered in the right order and lapped the right direction. Get it wrong and the leak comes back worse, sometimes under your warranty, sometimes into the frame itself. We’d rather you check from the ground and let us handle the roof. Call (833) 762-8116 and we’ll come look.
FAQs
Expect 15 to 25 years for the roof section if it’s properly flashed, and less on the sun-exposed edge facing south or west. Our inland heat, dry summers, and occasional hard rainstorms age flashing and caulk faster than the rest of the roof, so the joint above the door is usually the first spot to fail. Call (833) 762-8116 for a free look.
Often, yes. If the leaking is confined to the flashing and trim around the entry, a targeted repair usually solves it without touching the whole roof. We check the decking before we recommend anything, and we won’t push a full replacement if a repair does the job. Call (833) 762-8116 to schedule a free estimate.
Most flashing and trim repairs around an entry wrap up in a single day, weather permitting. Larger section re-roofs or decking replacement can run two to three days. We give you a realistic window in writing, not a guess over the phone.
We match parts to your actual Therma-Tru model and roof profile by measuring the rough opening and photographing the joint, then order what fits from suppliers we trust. We don’t carry parts in stock, so we’ll confirm lead time with you before we book the work. Call (833) 762-8116 for a free estimate.
If you’d rather talk it through in person, that’s how we prefer it too. Barrett & Sons Construction has been owner-operated since 1998, every eligible job gets its permits pulled and inspections signed, and every price change shows up on paper before the work moves. We install premium brands you can look up – GAF and CertainTeed on roofs, Andersen and Marvin on windows, KraftMaid and Cambria in kitchens, plus Silestone for counters. Call (833) 762-8116 for a free estimate on your Therma-Tru roofing work in Santa Clarita, and we’ll get a written scope in front of you.
Written by the team at Barrett & Sons Construction Santa Clarita.